Dishwasher Repair in Centennial, CO

Centennial dishwashers work hard, and local water works against them: mineral scale narrows spray-arm holes and films the filter. Most repairs run $160 to $300. The visit is $89, credited to the repair. We work the problem in order — filter and arms, drain path, fill parts, then seals and controls.

📞 Talk to an Appliance Repair Specialist: (983) 900-5287

Frequently Asked Questions

How much does dishwasher repair cost in Centennial?

Most repairs run $160 to $300. The visit is $89, credited to the repair. Pumps sit in the middle; seals and filters run low.

Is water in the bottom normal?

A bit over the filter is normal — it keeps seals wet. Water over the tub floor that stays a day is a drain problem. Rinse the filter first, then book if it stays.

Why do my dishes come out gritty?

Scale in the spray arms and a filmed filter are the top causes here, thanks to hard local water. Both are cleaned or swapped in one visit.

My dishwasher leaks at the door. Why?

A worn seal, a warped door, or a weak latch. Seals are a one-visit fix in most cases.

It will not start at all. What is it?

The latch and its switch are tested first — the unit will not run until the door latch clicks shut. Controls come second.

What Does My Appliance Repair Cost?

Appliance repair is priced per job — by the part that failed, not by the hour. Here are the ranges we see on real jobs around Centennial, and a calculator built on the same numbers. The $89 service visit is credited to your repair when you go ahead.

Refrigerator & Freezer

Most refrigerator repairs land $200 to $300 — a fan motor, a defrost part, a control. The freezer circuit runs $200 to $400, and an ice maker runs $150 to $350. Sealed-system work — a compressor — is priced at the visit, never off a chart. The $89 visit fee is credited to the repair.

Washer & Dryer

A washer drain, pump, or belt repair runs $150 to $280; a motor or control runs $250 to $450. A dryer element or thermal part runs $100 to $250; a dryer motor or board runs $250 to $400. You get one price in writing before work starts.

Dishwasher

A pump, valve, or inlet repair runs $160 to $240; a motor or control runs $220 to $300. Standing water is usually a drain or pump problem — and the fix is quoted whole, parts and labor together, at the visit.

Oven, Stove & Cooktop

An igniter, element, or switch runs $150 to $300; a cooktop surface repair runs $100 to $300; a control board or gas valve runs $300 to $500. Gas work is tested for leaks before the tech leaves — every time.

Microwave

A door switch, fuse, or light repair runs $100 to $200; a magnetron or control runs $200 to $300. On an older countertop unit the honest answer is sometimes replacement — the tech will show you both numbers.

What Moves the Price

  • The part. A defrost timer and a control board cost very different amounts. Every range here is keyed to the part class — and the written quote at the visit names the exact part before work starts.
  • The $89 visit, credited. The service visit is $89 and it comes off the repair when you go ahead. If the fix is only the visit — a clogged filter, a tripped breaker — the $89 is the whole bill.
  • Brand and age. Parts for some premium brands run higher and take a day or two to land. The quote says which, before you decide.
  • Repair or replace. If a repair passes about half the cost of a comparable new appliance, the tech shows you both numbers. Sometimes the right call is a new machine — we would rather tell you that than sell a repair that will not hold.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on parts. Most repairs here are figured with the part, the labor, and the credited $89 visit together. If a part has to be ordered, the quote says so up front with the day it lands — no open-ended waits, and the visit fee is never charged twice.

Estimate Your Repair

1 · Pick your appliance

A compressor or sealed-system problem is priced at the visit — never off this chart. The $89 visit is credited to the repair.

Free — no obligation. Your calculator numbers ride along with the request.

A technician checking inside an open dishwasher with a flashlight in Centennial, CO

One call, start to end

A Foxridge dishwasher held water over its tub floor for days. The filter and hose tested clear; the drain pump hummed and moved nothing. A new pump went in and two test cycles drained dry.

Service performed
Dishwasher Repair.
Scope of work
Pull the unit, test the drain pump, fit a new pump, and run two full cycles with a leak check.
Materials / products used
Drain pump.
Size
Built-in dishwasher, standard tub.
Final price
$286.
Cost per sq ft
Not applicable — appliance repair is priced per job, not per sq ft.
Turnaround / duration
Same day, about 2 hours on site.
Payment terms / financing
The $89 visit fee was credited to the repair. The rest was paid at the visit.
Problem found
Drain pump hummed and moved no water. Impeller worn.
Solution delivered
New pump fitted. Tub drained dry on both test cycles.
Homeowner first name
Dan.
Homeowner city / neighborhood
Centennial — Foxridge.
Homeowner situation (in their own terms)
Water sat in the bottom for two days and started to smell. We went back to hand-washing for a week.
Outcome and homeowner reaction
The tub drains dry now. Dan ran a load that night: 'First clean cycle in a month.'

Signs that point to this service

Not sure which one you have? Run the symptom check.

What usually causes it

Clogged filters and scaled spray arms head the cleaning list. Drain pumps, blocked hoses, and air-gap clogs cause standing water. Inlet valves and float switches handle fill problems. Door seals, a warped door, or a weak latch cause most leaks. Control and motor problems sit behind no-start and noise calls.

Safe checks you can try first

Pull the filter and rinse it — on most models it twists out by hand. Clear scale and seeds from the spray-arm holes. Make sure no tall pan blocks the top arm. If water covers the tub floor a day later, stop running cycles and book; do not pour drain cleaner in.

Questions about dishwasher repair

Need help in Centennial?

Call (983) 900-5287 or send the form. We'll tell you what the job needs and what it should cost before any work starts.

Request a repair visit

Related services: Oven Repair, Stove and Range Repair, and Freezer Repair.

Also serving: Appliance Repair in Greenwood Village, Appliance Repair in Lone Tree, and Appliance Repair in Englewood.

📞 (983) 900-5287